Can provide a hybrid, pure polyester powder coating art patterns of various kinds of resin
type, which are suitable for indoor or outdoor use. This product has a unique and luxurious
decorative effect, can help cover up the defects of the substrate itself. Widely used in
all kinds of high-grade metal products.
For metallic powder coating, should pay attention
to the following two points: 1 for this type of products containing metal paint, should
ensure that the system is well grounded in the use of electrostatic gun construction, while
setting a lower voltage and electrostatic powder amount, to prevent ignition phenomenon
when spraying. 2 in order to improve the decoration of the coating and to overcome the easy
cleaning of the metal pigment, we recommend the use of transparent powder coating to cover
the light.
Product series:
Can provide sand lines, hammer lines, silk patterns, marble lines,
metal appearance, and other products of a variety of effects.
Can provide a variety of
products according to the needs of users. (we do not recommend the use of gloss meter to
measure the gloss of the art film)
Physical properties of powder:
Proportion: 1.2-1.8 (due to
different color and luster)
Particle size distribution: 100% less than 100 microns (specific
indicators depending on the effect of fine arts, can be adjusted according to the special
requirements of the painting)
Liquidity: 120-140
Curing conditions: according to the product
of the resin type and set, specific please refer to the product with the attached
instructions.
Film properties
Test item
Inspection standard or method
Test index
Impact
resistance
ISO6272
GB/T1732-1993
30-50cm
Cupping test
ISO1520
GB/T9753-1988
6mm
Adhesion (grid
method)
ISO2409
GB/T9286-1998
0
Bend
ISO1519
GB/T6742-1986
3mm
Pencil hardness
ASTMD3363
GB/T6739-
1996
1H-2H
Salt spray test
ISO7253
GB/T1771-1991
>500 hours
Damp heat test
ISO6270
GB/T1740-1979
>1000 hours
Note:
More than 1 of the test with 0.8 mm thick rust and oil removal cold-rolled
steel plate, the film thickness is 60-80 microns.
2 the performance index of the film may
vary with the fine arts and the types of the resin.
Average coverage: 8-11 square meters /
kg, film thickness of 70 microns (to 100% of the powder coating usage)
Recommended film
thickness: we suggest that the thickness of the film is 60-80 microns.
Packaging: carton
packaging, lined with two layers of polyethylene bags, 20 kg net weight per box.
Storage
requirements: stored below 35 degrees Celsius, ventilation, dry, clean room, not close to
the fire, heating, avoid direct sunlight, no open pit. Under the above conditions, the
powder can be stored stably for 12 months. Over the storage period can be re inspection, if
the results meet the requirements, can still be used.
Health and safety: the powder coating
is a non-toxic product, but in the use of the process should avoid the inhalation of dust.
Suggested that the operator wear suitable dust masks, glasses. If possible, try to avoid
long-term contact with the skin and powder coating.