basic requirement for powder coating spray

Anti - electrostatic powder coating, which is a recent popular material, this material can not only be limited to electricity, it will also have a role in other areas, where only the function of discharge. The material of construction is also very strange, although it is used to prevent electric but its construction principle is the use of electric, electrostatic powder spray electricity to anti electric stuff construction, this material than a general electrostatic 

agent better effect. Glue we all know is a used to bond the or is used for filling of, but there are no people know this product is anti electric, the anti electric glue is electrostatic glue, the nature of the product has not only the adhesive, as well as the anti electricity 

function, where some of the characteristics of water will be to use. 

Film in addition to the static electricity is a special product in addition to electricity, in addition to the use of power after the rest can be assured that there will not be any problem.

In the use of powder coating equipment to be in accordance with the standard operation, the correct use of equipment is also a way to improve the quality of. To improve the quality of electrostatic powder spraying not only good electrostatic powder coating, but also the correct use of electrostatic dusting device. Standard for operation of powder electrostatic spraying. Look at some of the defects caused by improper operation of the spray powder. After the 

completion of the flaw has three main points, one is to look uneven thickness, the color is not uniform, with rough surface. Another is coated with a thick, so that the inner layer is not easy to do, there will be skin. The last point is that the electrostatic powder is not finished, the coating is too thin, did not reach the required thickness.

We have the requirements of electrostatic powder spraying technology is divided into the following aspects: in the use of electrostatic powder factory products before, we must clean up 

the surface of the workpiece, so that can make the use of longer life. In the construction of the workpiece, we must ensure that the workpiece is fully grounded, so that the efficiency of the 

construction can be guaranteed. If the construction of the workpiece has a larger defect, this time should be made to make up for these defects, and then in the use of electrostatic powder coating powder coating products. A good electrostatic powder spraying technology can improve the life of the work piece, so it is necessary to ensure that the temperature is standard. Electrostatic powder spraying manufacturers to remind everyone, after the completion of the construction should be careful to check the effect of construction. If there is a large defect must be re construction.